Back to HomeNittoku America Inc.


@@@@@@ SUPPORT @@@@@@ >> MENU >> Motion Control Software Requirements ================================================== for Win NT4.0 & 2000 Computer ===========================================


 
*Applicable Win. NT & 2000 is Ver.4.30A (first editon) or later


The Software available to use 1 : MPE720 (now Ver.5.3)
__________Controller Type: NSC30/40/50 or later

The Software available to use 2 : CP717
__________Controller Type: NSC30/40



Hardware requirements:

======== MPE720 =====================================================================

Type 1: Hardware Serial Port RS-232C for NSC30/40 Controller + Ethernet modem connectivity for NSC50 Controller

Type 2: USB/Serial RS-232C Adapter Device for NSC30/40 Controller + Ethernet modem conectivity for NSC50 Controller

PC architecture ____ DOS/V
CPU ___ Pentium 200 MHz or better
Memory ___ 64MB minimum (128MB recommended)
Resolution ___ 800 x 600 pixels
Hard disk ___ 200 MB free space minimum



======== CP717 =======================================================================

Type 1: Hardware Serial Port RS-232C for NSC30/40 Controller

Type 2: USB/Serial RS-232C Adapter Device for NSC30/40 Controller

PC architecture ____ DOS/V
CPU ___ Punting 200 MHz or better
Memory ___ 64MB minimum (128MB recommended)
Resolution ___ 800 x 600 pixels
Hard disk ___ 200 MB free space minimum